Profibus node address of the fieldbus module Displays current baud rate on the Profibus network. Do you need a help? Standard Application Program 6. The value cannot be adjusted by the user. The parameter will continue to be updated with the contents of PZD3 in each Request frame until a different selection is made. To use this website, you must agree to our Privacy Policy , including cookie policy. In addition to the safety instructions given below, read the complete safety instructions of the specific drive you are working on. 
| Uploader: | Mikazil |
| Date Added: | 12 May 2018 |
| File Size: | 21.97 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 79648 |
| Price: | Free* [*Free Regsitration Required] |
After switching off the mains, always allow flba-01 intermediate circuit capacitors 5 minutes to discharge before working on the frequency converter, the motor or the motor cable.
With the Transparent modes, no data conversion takes place. ABB drives can receive control information from multiple sources including analogue and digital inputs, the drive control panel and a communication module e. It is also possible to send a command to several nodes at the same broadcast; in this case the nodes do not send a response message to the master. The cable should be connected to the D-SUB connector as follows: The drive manuals are referred fsd at various points of this document.
The content is defined by a decimal number in the range of 0 to as follows: Effective if control location parameterised to be selected from fieldbus.
Diagnostics explains how to trace faults fpva-01 the status LEDs on the adapter module. The minimum and maximum bit integer values that can be given through the fieldbus are and respectively. Safety instructions are featured in the first few pages of this manual.
If this parameter is undefined, the communication between the drive and the module has not been established. ABB general purpose drives.
ABB fieldbus options. User s manual FPBA-01 PROFIBUS DP adapter module
Also referred to as node. SSW and 04 Software: Retain last Control Word ged Reference. The value cannot be adjusted by the user.
References in speed control mode In speed control mode, references are bit or bit words containing a sign bit and a bit or bit integer. The subindexes of these parameters are related to each other, i.
The maximum length of the bus cable is to meters, depending on the selected transmission rate see chapter Technical data. Some PLCs handle this internally, but others must be programmed to transmit data-consistent telegrams for more information, see the chapter Communication. fpbs-01
Read this chapter before you start the installation. Gsdd values Actual values are bit or bit words containing information on the operation of the drive.
Configuring The Master Station - Abb FPBA PROFIBUS DP User Manual [Page 82]
Subindex Contents See parameter It s the Interplay that makes the difference. Carefully read the instructions contained herein as gzd provide More information. It will also show the user how to. PPO message types Communication Phone: See Figure 7 on page The cyclical frame types supported by the module are defined in the GSD file.
ABB FPBA-01 PROFIBUS DP Adapter Module User`s Manual
Ignoring the following instructions can cause physical injury or death, or damage to the equipment. Select the appropriate CAN Method.
Contents Contents Introduction Safety References References are bit words containing a sign bit and a bit integer. Shows the fieldbus adapter type as detected by the drive. The communication with the module is activated with a drive parameter.
No comments:
Post a Comment